Before you begin: device is carrier-unlocked (Settings → General → About → Carrier Lock must say No SIM restrictions), QR code or activation code is ready, connected to Wi-Fi, and if two SIMs are already active temporarily disable one.
Tip: Important: this eSIM profile installs on one device only. Once you complete installation here, the profile cannot be reinstalled on another device. If you change phones later, request a new profile through your MyBundle account.
Tip: Before you start: if you're connected to a VPN, turn it off before installing. An active VPN can block the install from completing. You can turn it back on once your eSIM is installed and connected.
Option 1 — QR code (recommended when you have a second device)
• Settings → Mobile Service → Add eSIM → Use QR Code
• Point your iPhone camera at the QR code displayed on the other device
• Tap Continue and follow the on-screen steps
Option 2 — QR code on the same device
• Settings → Mobile Service → Add eSIM → Use QR Code → Enter Details Manually
• iOS will offer to use the code it detected in your email or clipboard
• Follow the on-screen steps
Option 3 — Manual activation code
• Settings → Mobile Service → Add eSIM → Use QR Code → Enter Details Manually
• Paste your full activation code including LPA:1$
• Tap Next and follow the on-screen steps
After installation
Set the new line as your primary data line under Settings → Mobile Service. Signal should appear within a few minutes.